office.
(586) 468-8847Disc Brake Calipers
Remanufacturing Process
Every Remanufactured Disc Brake Caliper undergoes the following vigorous remanufacturing process:
- Complete Disassembly
- Baked in Burn-Off Oven For 8 hours @700 degrees
- Blasted with 110 steel shot
- Dipped in rust-inhibitor solution
- Painted with Stainless Steel Paint
Building Process
Every Remanufactured Disc Brake Caliper undergoes the following building process:
- Completely Chase all Threads
- Seat new new OEM specified Bleeder Screw
- Install new OEM specified piston seal
- Install OEM specified piston with heavy body silicone grease
- Install new OEM specified piston boots
- Replace all rubber components with new
- Equipped with new crush washers/seats
- Visual Inspection and Leak Pressure Tested
- Lined with VCI paper and boxed with a barcode
Key Benefits
- Long Lasting Quality
- Remanufactured are only the component parts that have no effect on the performance or life of the disc brake caliper
- Complete with new rubber bushing installation kit